Switch for PowerBoost
We'll wired up a slide switch to the PowerBoost 1000C. Make two pieces of wire about 14cm in length – I used 26AWG. Prep the slide switch by cutting off one of the legs, either the far left or right, but not the middle! Then, trim the remaining two legs so they're about half the length.
Tin Wires
Using wire strippers, remove a bit of insulation from the tips of both wires. Then, tin the bare strands of wire by adding a tiny bit of solder to them. Add a piece of heat shrink tubing to keep the two wires together.
Text editor powered by tinymce.
