Build your own Bluetooth, remote-controlled robotic light switch to turn on and off the lights! Using CircuitPython running on the Feather nRF52840 Express and Crickit FeatherWing to flip the switch with a servo motor, you can avoid all of the complexities and dangers of high voltage mains wiring!
The 3D printed actuator, mount, and case makes it reliable and tidy. And the Adafruit Bluefruit app running on your iOS or Android device makes it fun and easy!
The Adafruit Feather nRF52840 Express is the new Feather family member with Bluetooth Low Energy and native USB support featuring the nRF52840! It's...
guides with product
$24.95
In Stock
Sometimes we wonder if robotics engineers ever watch movies. If they did, they'd know that making robots into servants always ends up in a robot rebellion. Why even go down that...
guides with product
$29.95
In Stock
Tiny little servo can rotate approximately 180 degrees (90 in each direction) and works just like the standard kinds you're used to but smaller. You can use any servo...
$5.95
In Stock
This is an FCC/CE certified and UL listed power supply. Need a lot of 5V power? This switching supply gives a clean regulated 5V output at up to 2000mA. 110 or 240 input, so it works...
$7.95
In Stock
Totaling 380 pieces, this M2.5 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel your maker...
guides with product
$16.95
In Stock
In addition to the parts above you'll also need:
- 8 ea. Heat-set, M2.5 x 0.45mm threaded inserts
- Soldering iron
- Small Philips screwdriver
- Slotted screwdriver
- 3D printer and PLA filament
Page last edited March 08, 2024
Text editor powered by tinymce.
