Wiring Parts

Get the components ready for wiring. The 10-wire silicone cover ribbon wire is recommended for soldered connections.

Switch Wiring

Use a piece of 2-wire ribbon wire that is 56mm in length. Solder to the middle and either far left or right pin. 

Wiring DRV2605L

Use a piece of 4-wire ribbon cable 70mm in length. Solder wires to the SDA, SCL, VIN and GND pins.

Wiring Common Ground

Solder the ground wire from the DRV2605L to the middle pin on the switch. These components share common ground. 

Motor Wiring

The wires from the vibration motor are soldered to a piece of 2-wire ribbon cable 40mm in length.

Wire Motor to DRV2605L

The two wires from the vibration motor are soldered to the voltage and ground motor pins on the DRV2605L breakout.

Wiring to Feather

The wires from the switch and DRV2605L are soldered to the pins on the Feather.

Circuit Wired

Solder the SDA, SCL and VIN wires from the DRV2605L to the SDA, SLC and 3V pins Feather. Solder the wires from the switch to the GND and EN pins on the Feather.

This guide was first published on May 19, 2020. It was last updated on May 19, 2020.

This page (Wiring) was last updated on May 17, 2020.

Text editor powered by tinymce.