Hardware for Feathers

Use the following hardware to secure the Feather to the PCB holder.

  • 4x M2.5 x 10mm screws
  • 8x M2.5 hex nuts

Install Screws and Nuts to Feather

Insert the 4x M2.5 x 10mm screws through the Feathers mounting holes. Then, insert and fasten hex nuts onto the thread of the screws. 

The nuts serve as very-low profile standoffs. This helps to elevate the Feather when installed to the holder. 

Installing Feather to PCB Holder

The speaker and battery must be connect BEFORE securing the Feather to the PCB holder.

Please note: Once the Feather is mounted to the PCB holder, the speaker and battery connection will not be accessible.

Connect Speaker to PropMaker

Plug in the speaker to the audio port on the PropMaker FeatherWing.

Connect Button to PropMaker

Grab the 4-pin picoBlade connector from the button and the Feather.Connect the 4-pin picoBalde cables together.

Connect Battery to Feather

Plug in the battery to the battery port on the Feather board.

Test Circuit

Let's test the circuit before installing the Feather board to the PCB holder.

Use the button to turn on the circuit. 

This guide was first published on Jan 19, 2021. It was last updated on Jan 19, 2021.

This page (Feather Assembly) was last updated on Jan 04, 2021.

Text editor powered by tinymce.