Angled shot of a Adafruit Feather M4 Express.
It's what you've been waiting for, the Feather M4 Express featuring ATSAMD51. This Feather is fast like a swift, smart like an owl, strong like a ox-bird (it's half ox,...
$22.95
In Stock
Four 30mm arcade buttons in order of color: blue, green, clear, and red. A white hand with a white painted manicure presses each of the arcade buttons.
The only thing better than a glowy arcade button is, perhaps, FOUR glowing arcade buttons - and that's what the Adafruit LED Arcade Button 1x4 QT I2C...
$9.95
In Stock
Angled shot of a Adafruit MIDI FeatherWing Kit.
Turn your Feather into a song-bird with this musically-enabled FeatherWing that adds MIDI input and output jacks to just about any Feather. You get both input and output DIN-5 MIDI...
$6.95
In Stock
Small Arcade Joystick with red ball
This snappy 8-way joystick beckons you to play with it! It is rugged, and not too large, reminiscent of a Pac Man arcade cabinet. Unlike the potentiometer-based 2-axis and mini...
$14.95
In Stock
Video of 30mm translucent red LED arcade button flashing on and off.
A button is a button, and a switch is a switch, but these translucent arcade buttons are in a class of their own. Particularly because they have LEDs built right...
$2.50
In Stock
Video of 30mm translucent clear LED arcade button flashing on and off.
A button is a button, and a switch is a switch, but these translucent arcade buttons are in a class of their own. Particularly because they have LEDs built right...
$2.50
In Stock
Triple prototyping feather wing PCB with socket headers installed
This is the FeatherWing Tripler - a prototyping add-on and more for all Feather boards. This is similar to our
$8.50
In Stock
Prototyping feather wing PCB with loose headers
A Feather board without ambition is a Feather board without FeatherWings!This is the FeatherWing Proto - a prototyping add-on for all Feather boards. Using our...
$4.95
In Stock
Breadboard-Friendly 3.5mm Stereo Headphone Jack
Pipe audio in or out of your project with this very handy breadboard-friendly audio jack. It's a stereo jack with disconnect-switches on Left and Right channels as well as a center...
$0.95
In Stock
Angled shot of STEMMA QT / Qwiic JST SH 4-pin Cable.
This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of...
$0.95
In Stock
Angled shot of JST SH 4-Pin Cable - 200mm Long.
This 4-wire cable is a little over 200mm / 7.8" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of...
$1.25
In Stock
SparkFun STEMMA QT / Qwiic breakout adapter
The SparkFun Qwiic Adapter can make any old I2C board or sensor a STEMMA QT / Qwiic-enabled...
$1.95
In Stock
Angled shot of a green round 16mm illuminated pushbutton.
A switch is a switch, and an LED is an LED, but this LED illuminated button is a lovely combination of both! It's a medium sized button, large enough to press easily but not too...
$1.50
In Stock
Angled shot of a yellow 16mm illuminated pushbutton.
A button is a button, and an LED is a LED, but this LED illuminated button is a lovely combination of both! It's a medium sized button, large enough to press easily but not too big...
$1.50
In Stock
Angled shot of ten 20 cm long quick-connect wire pairs.
Quick connector wire sets will make wiring up our arcade-style or metal buttons quicky-quick. Each wire comes as a 'pair' with two 0.11" quick-connects pre-crimped onto...
$4.95
In Stock
Pack of 10 through hole 10uF 50V Electrolytic Capacitors
We like capacitors so much we made a kids' show about them. ...
$1.95
In Stock
Angled shot of 25 Through-Hole Resistors - 1.0K ohm 5% 1/4W.
ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of...
$0.75
In Stock
Pack of 4 Little Rubber Bumper Feet
Keep your electronics from going barefoot, give them little rubber feet! These small sticky bumpers are our favorite accessory for any electronic kit or device. They are sticky, but...
$0.95
In Stock
Angled shot of two gray aluminum bumper feet.
Keep your electronics from going barefoot, and give them sleek cyberpunk metal feet! These aluminum bumpers are originally designed for keyboard enclosures that are made of anodized...
$8.95
In Stock