Download
The Reload Emulator is released as a UF2 file that is ready for loading onto the Adafruit Fruit Jam. Click the button below to download the latest release of of the emulator.
Plug your Fruit Jam into your computer with a known good USB (data+power) cable.
To enter the bootloader, hold down the BOOT/BOOTSEL button (highlighted in red above), and while continuing to hold it (don't let go!), press and release the reset button (highlighted in blue above). Continue to hold the BOOT/BOOTSEL button until the RP2350 drive appears on your Computer (in Finder or File Explorer depending on your operating system)!
If the drive does not appear, release all the buttons, and then repeat the process above.
You can also start with your board unplugged from USB, press and hold the BOOTSEL button (highlighted in red above), continue to hold it while plugging it into USB, and wait for the drive to appear before releasing the button.
A lot of people end up using charge-only USB cables and it is very frustrating! Make sure you have a USB cable you know is good for data sync.
You will see a new disk drive appear called RP2350.
Drag the apple2e.uf2 file downloaded from the green button above to the RP2350 drive.
After the file copy is complete, the Fruit Jam will reset and begin running the Apple //e emulator.
With a DVI compatible display connected, it will show the boot sequence below.
If there are speakers or headphones connected to the 3.5mm audio jack, the infamous beep sound will play.
Page last edited
Text editor powered by tinymce.
