Solder Slide Switch

Measure wires for the slide switch to reach the cutouts on the case, about 25mm long.

ANO Rotary Breakout and Encoder Wheel

Install the rotary wheel to the ANO STEMMA QT breakout by orienting pins in the correct the holes.

Solder all of the pins on the ANO rotary encoder wheel to the ANO STEMMA QT breakout.

Connect a 50mm long STEMMA cable to the right STEMMA port as shown.

Mount Lipo Battery

Thread the battery wire through the cutout on the case. Align the battery lid part to the snaps on each side of the case.

Connect battery to Feather

Plug the battery into the Feather before mounting the board to the case. 

Align the USB C port on the Feather to the cutout on the case.

Use M2.5x5mm screws on the screws holes near the USB C port.

Finish mounting the Feather board with M2x5mm screws on the smaller screw holes.

Press Fit the Slide Switch

Angle the slide switch and press fit into the cutout on the side of the case.

Connect ANO rotary

Plug the STEMMA cable into the port on the Feather.

Align the ANO board with the Adafruit logo pointing up and the through hole pins pointing down towards the USB C port as shown.

The ANO rotary board mounts to the standoffs with M2.5x5mm screws.

Attach Watch

Align the Apple Watch crown and button to the cutouts on the case.

The screen lid press fits onto the snaps on the side of the case.

Attach ANO lid

Align the cutout on the case lid to the ANO and press fit on the snaps on each  side of the case.