Top down view of a Adafruit CRICKIT for Circuit Playground Express with a circular board connected.
Sometimes we wonder if robotics engineers ever watch movies. If they did, they'd know that making robots into servants always ends up in a robot rebellion. Why even go down that...
$29.95
In Stock
A Black woman's manicured hand holds a round microcontroller with lit up LEDs.
Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. We've taken the original Circuit Playground Classic and...
$24.95
In Stock
Standard hobby servo with three pin cable
This high-torque standard servo can rotate approximately 180 degrees (90 in each direction). You can use any servo code, hardware, or library to control these servos. Good for...
$12.00
In Stock
Angled shot of black 3 x AA waterproof battery holder with plain wires.
Keep your power source safe and toasty in these waterproof 3xAA battery holders. They're just like classic switched battery holders, but designed for survival! The case has a rubber...
$3.95
In Stock
Angled shot of a Male DC Power adapter - 2.1mm plug
If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm DC plug on one end, and a screw...
$2.00
In Stock
Angled shot of 3 AA batteries.
Battery power for your portable project! These batteries are good quality at a good price, and work fantastic with any of the kits or projects in the shop that use AAs. This is a pack...
$2.25
In Stock
5V 4A switching power supply brick with figure 8 power port.
Need a lot of 5V power? This switching supply gives a clean regulated 5V output at up to 4 Amps (4000mA). 110 or 240 input, so it works in any country. The plugs are "US...
$14.95
In Stock
Thin Plastic Speaker with Wires
Listen up! This 1.5" diameter speaker cone is the perfect addition to any audio project where you need an 8Ω impedance and are using 0.25W of power. The speakers are rated...
$1.75
In Stock