PowerBoost 1000C ResistorIn order to make the potentiometer switch work with the PowerBoost, a 10k resistor is used. Get the 10K resistor ready to install onto the PowerBoost 1000C. |
|
Install 10K ResistorFit the legs of the resistor through the EN and GND pins on the PowerBoost 1000C. Secure the PowerBoost 100C to a PCB vise or set of third helping hands. Solder the resistor to the EN and GND pins on the PowerBoost 1000C. |
|
Cables for PowerBoost 1000CUse the following cables for wiring up the PowerBoost 1000C.
|
|
Solder Cables to PowerBoost 1000CSolder one of the 2-wire cables to the 5V and GND pins on the PowerBoost 1000C. Solder the second 2-wire cables to the voltage and ground pins on the PowerBoost 1000C. Solder the 2-pin JST cable to the EN and VS pins on the PowerBoost 1000C. |
|
Wired PowerBoost 1000CDouble check all of the wires have been soldered to the PowerBoost 1000C. |
PowerBoost 1000C Wiring
This guide was first published on Feb 24, 2021. It was last updated on 2021-02-23 19:16:05 -0500.
This page (PowerBoost 1000C Wiring) was last updated on Mar 16, 2021.
Text editor powered by tinymce.