CAD Files

STL files for 3D printing are oriented to print "as-is" on FDM style machines. Parts are designed to 3D print without any support material. Original design source may be downloaded using the links below.

Slice Settings

The parts were sliced using CURA and FlashPrint using the slice settings below.

• PLA filament 220c extruder
• 0.2 layer height
• 10% gyroid infill
• 60mm/s print speed
• 60c heated bed

Back Plate

The back plate requires a minimum build volume.

• Minimum Bed: 165mm x 135mm

Servo Assembly

The servo mounts are secured to the back plate with screws and nuts. The micro servo is fitted into the servo mount and secured with screws. A ball bearing is fitted into the servo mount to counter weight the servo arm. The servo arm is secured to a servo horn and press fitted onto the shaft of the servo motor. The servo arm is secured to the bearing pin with a long screw. The wing holder is secured to the servo arm with screws and hex nuts. The wings are attached to the wing holder with screws and hex nuts.

Battery Holder Assembly

The battery holder is secured to the back plate with screws. Lock nuts are press fitted into the battery holder. The 2200mAh battery slides through the clip.

PCB mount assembly

The Feather M4 and Servo FeatherWing are fitted onto the Doubler FeatherWing. The PCB mount is secured to the back plate with screws and additional standoffs. The Doubler is secured to the standoffs on the PCB mount.