FDM 3D Printing

These parts are optimized to print with desktop 3D Printers capable of printing in ABS or PLA material with a minium build area of 100mm x 100mm x 90mm.  The two parts are designed to print without any support material. 




10% infill

90 feed

120 travel

no supports or rafts

about 45 mins to print

Slicing Software

The recommend settings above should work with most slicing software. However, you are encouraged to use your own settings since 3D printers and slicing software will vary from printer to printer.

PLA or ABS Material

We recommend using PLA material for an easier print with high quality. The tolerance has been tested with PLA filament but should also work with ABS. The parts do not require any support material or a raft.

This guide was first published on Oct 13, 2014. It was last updated on Sep 24, 2014.

This page (3D Printing) was last updated on Oct 13, 2014.

Text editor powered by tinymce.