Manicured hand holding Trinket M0.
The Adafruit Trinket M0 may be small, but do not be fooled by its size! It's a tiny microcontroller board, built around the Atmel ATSAMD21, a little chip with a lot...
guides with product
$8.95
In Stock
Angled shot of board
Deprecation Warning: The Trinket bit-bang USB technique it uses doesn't work as well as it did in 2014, many modern computers won't work well. So while we still carry...
guides with product
$6.95
In Stock
Micro servo with three pin cable
Tiny little servo can rotate approximately 180 degrees (90 in each direction) and works just like the standard kinds you're used to but smaller. You can use any servo...
$5.95
In Stock
Bread-board friendly Piezo Buzzer
Piezo buzzers are used for making beeps, tones and alerts. This one is petite but loud! Drive it with 3-30V peak-to-peak square wave. To use, connect one pin to ground (either one) and...
$1.50
In Stock
Breadboard Friendly Panel Mount 10K potentiometer linear.
This potentiometer is a two-in-one, good in a breadboard or with a panel. It's a fairly standard linear taper 10K ohm potentiometer, with a grippy shaft. It's smooth and easy...
$0.95
In Stock
Close up head of CdS light sensor showing sensor element
CdS cells are little light sensors. As the squiggly face is exposed to more light, the resistance goes down. When it's light, the resistance is about ~1KΩ, when dark it goes...
$0.95
In Stock
Top view of three fanned out Adafruit Perma-Proto Quarter-sized Breadboard PCBs.
Customers have asked us to carry basic perf-board, but we never liked the look of most basic perf: it's always crummy quality, with pads that flake off and no labeling. Then we...
guides with product
$8.50
In Stock
Front angled shot of 3 x AAA battery holder with on-off switch and 2-pin JST PH connector.
This battery holder connects 3 AAA batteries together in series for powering all kinds of projects. We spec'd these out because the box is slim, and 3 AAA's add up to about...
$1.95
In Stock
Angled shot of 2 Alkaline AAA batteries.
Battery power for your portable project! These batteries are good quality at a good price, and work fantastic with any of the kits or projects in the shop that use AAA's. This...
No Longer Stocked
pack of five, 36-pin 0.1 inch Female header
Female header is like the duct tape of electronics. Its great for connecting things together, soldering to perf-boards, sockets for wires or break-away header, etc. We go through these...
$2.95
In Stock
10 pieces of Break-away 0.1 inch 36-pin strip male header
Breakaway header is like the duct tape of electronics. It's great for connecting things together, soldering to perf-boards, fits into any breakout or breadboard, etc. We go through...
Out of Stock
Small spool of yellow wire
Perfect for bread-boarding, free wiring, etc. This spool of solid-core wire is easy to solder to. When bent it keeps its shape pretty well. We like to have a few spools of this stuff...
$2.95
In Stock
Small spool of red wire.
Perfect for bread-boarding, free wiring, etc. This spool of solid-core wire is easy to solder to. When bent it keeps its shape pretty well. We like to have a few spools of this stuff...
Out of Stock
Small spool of black wire
Perfect for bread-boarding, free wiring, etc. This spool of solid-core wire is easy to solder to. When bent it keeps its shape pretty well. We like to have a few spools of this stuff...
$2.95
In Stock
Premium Female/Female Jumper Wires - 40 x 6"
Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires approximately 6" (150mm) long and come in a 'strip' of 40 (4 pieces...
$3.95
In Stock
Lithium Ion Polymer Battery 3.7v 1200mAh with JST 2-PH connector
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
Out of Stock