Adafruit TMP007 Sensor Breakout

Prepare the header strip:

Cut the strip to length if necessary. It will be easier to solder if you insert it into a breadboard - long pins down

Place the breakout board over the pins so that the short pins poke through the breakout pads

Be sure to solder all pins for reliable electrical contact.

(For tips on soldering, be sure to check out our Guide to Excellent Soldering)..

You're done! Check your solder joints visually and continue onto the next steps

This guide was first published on Aug 05, 2014. It was last updated on Aug 05, 2014.

This page (Assembly) was last updated on Aug 12, 2022.