Pinouts

The Si7021 is a I2C sensor. That means it uses the two I2C data/clock wires available on most microcontrollers, and can share those pins with other sensors as long as they don't have an address collision. For future reference, the I2C address is 0x40 and you can't change it!

Power Pins:

  • Vin - this is the power pin. Since the chip uses 3 VDC, we have included a voltage regulator on board that will take 3-5VDC and safely convert it down. To power the board, give it the same power as the logic level of your microcontroller - e.g. for a 5V micro like Arduino, use 5V
  • 3v3 - this is the 3.3V output from the voltage regulator, you can grab up to 100mA from this if you like
  • GND - common ground for power and logic

I2C Logic pins:

  • SCL - I2C clock pin, connect to your microcontrollers I2C clock line.
  • SDA - I2C data pin, connect to your microcontrollers I2C data line.
This guide was first published on Sep 22, 2016. It was last updated on Sep 22, 2016. This page (Pinouts) was last updated on Oct 20, 2019.