Prepare the header strip:Cut the strip to length if necessary. It will be easier to solder if you insert it into a breadboard - long pins down |
|
Add the breakout board:Place the breakout board over the pins so that the short pins poke through the breakout pads |
|
And Solder!Be sure to solder all pins for reliable electrical contact.(For tips on soldering, be sure to check out our Guide to Excellent Soldering). |
|
You're done! Check your solder joints visually and continue onto the antenna |
|
An antenna is required! We provide a 1meter long wire but you can also use a shorter or longer piece as desired. Strip a few mm from the end |
|
Hook the exposed wire end into the ANT hole |
|
Solder it in! |
|
Done! |
Assembly
This guide was first published on Jun 26, 2014. It was last updated on Jun 26, 2014.
This page (Assembly) was last updated on Jan 15, 2021.