The default I2C address is 0x59.

Power Pins

• VIN - this is the power pin. To power the board, give it the same power as the logic level of your microcontroller - e.g. for a 5V microcontroller like Arduino, use 5V. For a 3.3V microcontroller, use 3.3V.
• 3.3V - this is the 3.3V output from the voltage regulator, you can grab up to 100mA from this if you like.
• GND - common ground for power and logic.

I2C Logic Pins

• SCL - I2C clock pin, connect to your microcontroller I2C clock line. This pin is level shifted so you can use 3-5V logic, and there's a 10K pullup on this pin.
• SDA - I2C data pin, connect to your microcontroller I2C data line. This pin is level shifted so you can use 3-5V logic, and there's a 10K pullup on this pin.
• STEMMA QT - These connectors allow you to connect to dev boards with STEMMA QT connectors or to other things with various associated accessories.

Power LED

• Power LED - In the upper left corner, above the STEMMA connector, on the front of the board, is the power LED, labeled on. It is a green LED.