Pinouts

These mics are very simple!

  • 3V - This is the power input pin, this powers the chip directly. Use a quiet power supply pin if available. (The chip supports 1.8-3.3V but we have not tested it at 1.8V)
  • GND - Power and data ground reference
  • SEL - Left/Right select. If this pin is high, the output is on the falling edge of CLK considered the 'Right' channel. If this pin is low, the output is on the rising edge, a.k.a 'Left' channel.
  • CLK - PDM clock in, 1 - 3 MHz square wave required
  • DAT - PDM data out.
Last updated on Jan 10, 2018 Published on Jan 10, 2018