|PCB||Printed Circuit Board||Adafruit||1|
Serial to parallel output latch
|IC1' and IC2'||
16 pin sockets (OPTIONAL!)
These are included in kits as of July 2010
3mm LED, any color
Motor power indicator
|R1||1.5K resistor for LED1||1/4W 5% resistor||1|
|R2||10K pulldown resistor
Brown, Black, Orange, Gold
|1/4W 5% resistor||1|
|RN1||10-pin bussed 10K-100K resistor network||100K resistor network||1|
|C2, C4, C6||0.1uF ceramic capacitor||Generic||3|
|C1, C3, C5||100uF / 6V capacitor (or bigger)||100uF/6V cap||3|
|C7, C8||47uF / 25V capacitor (or bigger)||47uF/25V cap||2|
5-position 3.5mm terminal block
(Or a 3-position and a 2-position)
|X2||2-position 3.5mm terminal block||3.5mm terminals||1|
|RESET||6mm tactile switch||6mm tact switch||1|
|36 pin male header (1x36)||Generic||1|
This tutorial is for the now ancient V1 Motor shield. Chances are you have a V2, check out the tutorial https://learn.adafruit.com/adafruit-motor-shield-v2-for-arduino This tutorial is for historical reference and previous customers only!
This guide was first published on Aug 27, 2012. It was last updated on Aug 27, 2012.
This page (Parts List) was last updated on Jul 06, 2020.