Pink polished fingers holding a Adafruit GEMMA M0 - Miniature wearable electronic platform.
The Adafruit Gemma M0 is a super small microcontroller board, with just enough built-in to create many simple projects. It may look small and cute: round, about the...
Out of Stock
Purple poslished fingers holding a Adafruit GEMMA v2 - Miniature wearable electronic platform.
Deprecation Warning: The Gemma bit-bang USB technique it uses doesn't work as well as it did in 2014, many modern computers won't work well. So while we still carry the...
$9.95
In Stock
Single LED sequin PCB attached to two alligator clips, glowing red
Sew a little sparkle into your wearable project with an Adafruit LED Sequin. These are the kid-sister to our popular Flora NeoPixel,...
$3.95
In Stock
Single LED sequin PCB attached to two alligator clips, glowing green
Sew a little sparkle into your wearable project with an Adafruit LED Sequin. These are the kid-sister to our popular Flora NeoPixel,...
$3.95
In Stock
Single LED sequin PCB attached to two alligator clips, glowing blue
Sew a little sparkle into your wearable project with an Adafruit LED Sequin. These are the kid-sister to our popular Flora NeoPixel,...
$3.95
In Stock
Single LED sequin PCB attached to two alligator clips, glowing white
Sew a little sparkle into your wearable project with an Adafruit LED Sequin. These are the kid-sister to our popular Flora NeoPixel,...
$3.95
In Stock
Close up of pink rose lit LED powered by two alligator clips
Sew a little sparkle into your wearable project with an Adafruit LED Sequin. These are the kid-sister to our popular Flora NeoPixel,...
$3.95
In Stock
Angled shot of closed 2 x 2032 coin cell battery holder with on-off switch and JST PH Connector.
This tiny coin cell battery holder is ideal for small portable or wearable projects. It holds two 20mm coin cells (2032 or CR2032 are the most popular size) in series to generate 6V...
$1.95
In Stock
Front shot of CR2032 Lithium Coin Cell Battery upright.
A perfect match for our sew-able coin cell holder. This non-rechargeable coin cell is CR2032 sized: 20mm diameter, 3.2mm thick. It...
Out of Stock
Angled shot of sewable CR2032 battery holder.
This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes in the metal connection tabs, just...
$1.95
In Stock
Top-down view of 6 pairs of short wire alligator clips.
Connect this to that without soldering using these handy mini alligator clip test leads. Approximately 4.5" overall cables with alligator clip on each end, color coded. You get 12...
Out of Stock
Stainless Thin Conductive Thread - 2 ply - 23 meter/76 ft
After months of searching, we finally have what we consider to be the ultimate conductive thread. It's thin, strong, smooth, and made completely of 316L stainless steel. Once you...
$6.95
In Stock