You will need the following parts for this tutorial:

• 1x Adafruit IO compatible Feather
• 2x jumper wires
• 1x 560 ohm resistor
• 1x 10mm LED

You will need to connect the following pins to the LED and resistor:

• Feather GND to LED cathode (short leg)
• Feather Pin 5 to one leg of the 560 ohm resistor
• LED anode (long leg) to the second leg of the 560 ohm resistor

Note: Resistors are not polarized, so the 560 ohm resistor can be connected to the circuit in either direction.