Break apart the 0.1" header into 6 and 9-pin long pieces and slip the short ends into the holes in the board
Make sure that all of the short parts of the header are sticking through the two sets of pads on either side of the board
Break apart the 0.1" header into 6 and 9-pin long pieces and slip the short ends into the holes in the board
Make sure that all of the short parts of the header are sticking through the two sets of pads on either side of the board
This guide was first published on Nov 21, 2017. It was last updated on Nov 21, 2017.
This page (Assembly) was last updated on Nov 21, 2017.
Text editor powered by tinymce.