The assembly images below show the similar TB6612 instead of the DRV8833 breakout but the procedure is identical!

Prepare the header strip:

Cut the strip to length if necessary. It will be easier to solder if you insert it into a breadboard - long pins down

Add the breakout board:

Place the breakout board over the pins so that the short pins poke through the breakout pads

And Solder!

Be sure to solder all pins for reliable electrical contact.

(For tips on soldering, be sure to check out our Guide to Excellent Soldering).

This guide was first published on Oct 26, 2016. It was last updated on May 23, 2024.

This page (Assembly) was last updated on Oct 26, 2016.

Text editor powered by tinymce.