Video of a haptic controller breakout board with a vibrating motor disc soldered to it. The disc vibrates against the surface.
The DRV2605 from TI is a fancy little motor driver. Rather than controlling a stepper motor or DC motor, its designed specifically for controlling haptic motors -...
$7.95
In Stock
Vibrating Mini Motor Disc with two wires
*BZZZZZZZZZZ* Feel that? That's your little buzzing motor, and for any haptic feedback project you'll want to pick up a few of them. These vibe motors are tiny discs,...
$1.95
In Stock
Angled of of JST SH 4-Pin Cable.
This 4-wire cable isĀ 50mm / 1.9" long and fitted with JST SH female 4-pin connectors on both ends. Compared with the chunkier JST PH these are 1mm pitch instead of 2mm, but...
Out of Stock
Angled shot of JST SH 4-pin Cable with Alligator Clips.
This cable will make it super easy to use our plug-and-play STEMMA QT boards with boards like Circuit Playground. On one end you get a Qwiic / STEMMA QT connector (technically known as...
Out of Stock
Angled shot of JST SH 4-Pin Cable - 200mm Long.
This 4-wire cable is a little over 200mm / 7.8" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of...
Out of Stock
Top view of JST SH 4-pin to Premium Male Headers Cable next to US quarter for scale.
This 4-wire cable is a little over 150mm / 6" long and fitted with JST-SH female 4-pin connectors on one end and premium Dupont male headers on the other. Compared with the...
Out of Stock
Angled shot of STEMMA QT / Qwiic JST SH 4-pin Cable.
This 4-wire cable is a little over 100mm / 4" long and fitted with JST-SH female 4-pin connectors on both ends. Compared with the chunkier JST-PH these are 1mm pitch instead of...
$0.95
In Stock