Assembly

Prepare the header strip:

Cut the strip to length if necessary. It will be easier to solder if you insert it into a breadboard - long pins down

Add the breakout board:

Place the breakout board over the pins so that the short pins poke through the breakout pads

And Solder!

Be sure to solder all pins for reliable electrical contact.

Solder the longer power/data strip first

(For tips on soldering, be sure to check out our Guide to Excellent Soldering).

You're done! Check your solder joints visually and continue onto the next steps

Attach Motor

We prefer to attach the little vibration motor directly to the Motor+ and Motor- pads

Solder in place

Check your work and continue!

This guide was first published on Dec 17, 2014. It was last updated on Dec 17, 2014. This page (Assembly) was last updated on Dec 05, 2019.