New
Beginner
Product guide
Pinouts
Power Pins
- 5V - These are the 5V power pins. They receive 5V output from USB and can supply ~100mA peak.
- 3V - This is the 3.3V power pin. It is the output from the 3.3V regulator and can supply ~100mA peak.
- GND - Common ground for power and logic.
Enhanced Port Pins
The enhanced port pins are broken out on the left side of the board.
- RX/RX1 - UART data receive pin. This pin receives the serial input. This pin is also available along the bottom edge of the board as RX1.
- TX/T1 - UART data transmit pin. This pin sends the serial output. This pin is also available along the bottom edge of the board as T1.
- DSR - Data Set Ready control input. This pin is active low.
- CTS - Clear To Send control input. This pin is active low.
- RTS - Ready To Send control output. This pin is active low.
- DTR - Data Terminal Ready control output. This pin is active low.
- RI - Ring Indicator control input. This pin is active low.
The enhanced port can handle baud rates from 300 bps to 2.0 Mbps and 320 Byte receive and transmit buffers. It supports the following data formats:
- Data bits: 5, 6, 7, and 8
- Stop bits: 1, 1.5, and 2
- Parity: odd, even, mark, space, no parity
Standard Port Pins
The standard port pins are broken out on the right side of the board.
- RX/R2 - UART data receive pin. This pin receives the serial input. This pin is also available along the bottom edge of the board as R2.
- TX/TX2 - UART data transmit pin. This pin sends the serial output. This pin is also available along the bottom edge of the board as TX2.
- DSR - Data Set Ready control input. This pin is active low.
- CTS - Clear To Send control input. This pin is active low.
- RTS - Ready To Send control output. This pin is active low.
- DTR - Data Terminal Ready control output. This pin is active low.
- RI - Ring Indicator control input. This pin is active low.
The standard port can handle baud rates from 2400 bps to 921600 bps and 288 Byte receive and transmit buffers. It supports the following data formats:
- 8 data bits
- 1 stop bit
- Parity: even, odd, no parity
Page last edited