Adafruit HUZZAH CC3000 WiFi Breakout with Onboard Antenna
For years we've seen all sorts of microcontroller-friendly WiFi modules but none of them were really Adafruit-worthy. Either they were too slow, or too difficult to use, or...
Discontinued
Adafruit CC3000 WiFi Breakout with uFL Connector for Ext Antenna
For years we've seen all sorts of microcontroller-friendly WiFi modules but none of them were really Adafruit-worthy. Either they were too slow, or too difficult to use, or...
Discontinued
Angled shot of a Adafruit HUZZAH CC3000 WiFi Shield with Onboard Antenna.
For years we've seen all sorts of microcontroller-friendly WiFi modules but none of them were really Adafruit-worthy. Either they were too slow, or too difficult to use, or...
Discontinued
Close up of a Adafruit CC3000 WiFi Shield with uFL Connector for Ext Antenna.
For years we've seen all sorts of microcontroller-friendly WiFi modules but none of them were really Adafruit-worthy. Either they were too slow, or too difficult to use, or...
Discontinued
Angled shot of a Adafruit METRO 328 Fully Assembled
We sure love the ATmega328 here at Adafruit, and we use them a lot for our own projects. The processor has plenty of GPIO, Analog inputs, hardware UART SPI and I2C,...
Out of Stock
DHT11 basic temperature-humidity sensor with 10K resistor
Discontinued - you can grab the DHT20 - AHT20 Pin Module - I2C Temperature and Humidity...
Discontinued
DHT22 temperature-humidity sensor with 10K resistor
The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air and spits out a digital...
Discontinued
Sensor module with three wires
Discontinued - you can grab AM2301B - Wired Enclosed AHT20 - Temperature and Humidity Sensor instead!The...
Discontinued
Angled shot of half-size solderless breadboard with red and black power lines.
This is a cute, half-size breadboard with 400 tie points, good for small projects. It's 3.25" x 2.2" / 8.3cm x 5.5cm with a standard double-strip in the...
Out of Stock
Angled shot of Premium Male/Male Jumper Wires - 40 x 3 (75mm)
Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 3" (75mm) long and come in a 'strip' of 40 (4 pieces of each of...
$3.95
In Stock