Prepare the header strip:Cut the strip to length if necessary. It will be easier to solder if you insert it into a breadboard - long pins down |
|
Add the breakout board:Place the breakout board over the pins so that the short pins poke through the breakout pads |
|
And Solder!Be sure to solder all pins for reliable electrical contact. |
|
You're done! Check your solder joints visually and continue onto the next steps |
Assembly
Your board may look a little different - the assembly process is the same!
This guide was first published on Jul 24, 2015. It was last updated on Jul 24, 2015.
This page (Assembly) was last updated on Jan 15, 2021.