Breadboard Layout

by Simon Monk

The breadboard layout for this lesson is the same as for lesson 8, except that the pot is replaced by an LDR and a 1 kΩ resistor.

Here is the layout for lesson 8, near the pot.

learn_arduino_fritzing_with_pot.jpg

Simply remove the pot and replace it with the photocell and resistor as shown below:

learn_arduino_fritzing_with_ldr.jpg
PARTS PHOTOCELLS
This guide was first published on Dec 11, 2012. It was last updated on Dec 11, 2012. This page (Breadboard Layout) was last updated on Aug 17, 2019.