0

Overview

by Simon Monk

In this lesson, you will start by using the Serial Monitor to display analog readings, and then extend the project using eight LEDs from lesson 4, so that you can control the number of LEDs that are lit by turning the knob on a variable resistor.

learn_arduino_overview.jpg
PARTS
Last updated on 2015-05-04 at 04.27.11 PM Published on 2012-12-10 at 10.42.38 AM

RELATED GUIDES

POPULAR
TTL Serial Camera
Snap, Snap!
by lady ada
This guide is for our new TTL serial camera module with NTSC video output. These modules are a nice addition to a microcontroller project when you want to take a photo or control a video stream. The modules have a few features built in, such as the ability to change the brightness/saturation/hue of images, auto-contrast and auto-brightness adjustment, and motion detection.
EL Wire
Working with Electroluminescent Wire
by lady ada
EL Wire, also known as Electroluminescent wire, is a stiff wire core coated with phosphor and then covered with a protective PVC sheath. When an AC signal is applied to it, it glows a cool neon color. Find out how to solder, power, and work with EL Wire in your next project.
Hacking the Kinect
Reverse engineering the Microsoft Kinect
by lady ada
Here's a step by step guide on how you can reverse engineer a Microsoft Kinect for the Xbox 360.
BeagleBone
Tutorials for the TI embedded Linux board
by lady ada
New from the fine people who have brought us the Beagle Board, we now have a smaller, lighter, but powerful single board linux computer, Beagle Bone! We like this move to a more compact and integrated SBC. For example, there is onboard Ethernet and USB host, as well as a USB client interface (a FTDI chip for shell access). It even comes preloaded with Angstrom Linux on the 4 GB microSD card! Here are some tips and tricks to get your BeagleBone up and running.