The breadboard layout is based on the layout from lesson 11, so if you still have this on the breadboard it will simplify things greatly.

There are a few jumper wires that have been moved slightly on this layout. In particular, those near the pot.

The photocell, 1 kΩ resistor and TMP36 are all new additions to the board. The TMP36 has its curved face towards the display.

This guide was first published on Dec 14, 2012. It was last updated on Dec 14, 2012.

This page (Breadboard Layout) was last updated on Dec 06, 2021.

Text editor powered by tinymce.