Fruit Jam Assembly
Film Removal
The first step in assembling your Fruit Jam is to remove the protective film from the three threaded standoffs.
One way to do it is to push a blunt instrument such as tweezers up from below to pop them off.
Speaker
Connect the oval speaker by plugging in the JST-SH connector to the Speaker Output connector on the Fruit Jam.
Then use the self adhesive on the back of the mini speaker to attach it on the board. (You can alternately attach it on the under side of the top plate.)
Top Plate
Carefully screw in the M3 screws to the mounting holes.
Do not tighten the screw nearest to the speaker connector all the way. There needs to enough of a gap to not pinch the wires coming from the JST-PH connector.
Bumper Feet
Nobody wants their cool little retro microcomputer/console sliding around all over the place, so let's add some rubbery feet.
Flip the Fruit Jam over and apply the four rubber bumper feet. Press each foot down firmly for ten seconds for good adhesion.
Page last edited December 13, 2025
Text editor powered by tinymce.
