Here's how to assemble the LED glasses, frames, LED Driver board, and battery pack.
Attach Glasses to Frames
Line up the frames with the glasses.
Using zip ties (colored purple here for illustration purposes), thread through the glasses holes and frame, then tighten the zip ties as shown.
Some AdaBoxes may come with larger-than-desired zipties due to supply chain surprises! If your zipties seem to be very difficult to pull through the holes of the LED glasses, don't force them! Get some smaller ones or use the twist tie method shown below.
Alternate Fastener
You can use wire as a sort of zip tie in case you don't have any appropriately sized zip ties on hand.
Just pass through the holes, twist, and snip to length.
Driver Board
Use two zip ties to attache the LED Driver board to the glasses temple as shown here.
Tighten and then snip the excess.
Power
Use the 3x AAA battery pack and JST PH cable to provide power to the glasses as shown.
You can extend the length using the extension cable shown below.
Page last edited March 08, 2024
Text editor powered by tinymce.
