We are going to build this music player right on the included breadboard. Start by plugging your HUZZAH Feather directly into the breadboard like this:
Then take your MusicMaker FeatherWing and plug it into the HUZZAH Feather:
Now, grab a small screwdriver and attach the speaker wires to the MusicMaker FeatherWing terminals. We are only going to use the one speaker, so it really doesn't matter which speaker channel you choose. You can put it in the right, or left side. Just make sure to connect the red (positive) wire to one of the outside terminals, and the black (negative) wire to one of the inside terminals.
In the picture below, you can see I attached the wires to the left channel with the red wire in the outside position.
Tighten the screws and we are ready to load some music onto the SD card.
Page last edited June 22, 2017
Text editor powered by tinymce.