Switch Holder

Get the switch ready to install into the switch holder.

Install Switch

Fit the switch into the holder at an angle and press fit into place. 

The switches actuator will poke through the opening of the holder.

Switch Holder Screws

Get the following hardware ready to secure the switch holder to the head cover.

• 2x M2.5 x 6mm long screws
• 2x M2.5 hex nuts

Secure Switch Holder

Place the switch holder over the head cover with the mounting holes lined up.

Insert and fasten the screws through the mounting holes and secure using the hex nuts.

Installed Switch Holder

Double check the switch holder has been properly secured to the head cover.

Install Head Cover

Insert the wires from the slide switch through the neck.

Snap Fit Head Cover

Begin joining the head cover to the head case by snap fitting them together.

Installed Head Cover

Double check the head cover has been properly joined to the head case with all of the wires fitted through the neck.