Servo Cable

The stock cable in the micro servo is a bit too long and could cause issues so it's shortened.

Cut the wires short so the total length is 14cm

Rewiring Servo Cable

Remove a bit of insulation from the wires and add a bit of solder to prevent the strands of wire from fraying.

Add pieces of heat shrink tubing to each wire. Then, solder the wires together.

Wired Servo

Double check the wires have been properly soldered together.

Servo Horn & Gear

Get the servo horn, screw and 3D printed gear ready to assemble.

Trim Servo Horn

Using flush snips, remove the wing from the horn, leaving just the center part.

Install Servo Horn

Press fit the trimmed horn onto the shaft of the servo.

Install Servo Gear

Place the 3D printed servo gear over the horn and line up the mounting hole.

Insert and fasten the included hardware screw through the top of the 3D printed servo gear.

Servo Gear

Ensure the gear has been fully tightened and flush with the servo horn.

Servo Mount

Get the following hardware ready to install the micro servo to the servo mount.

• 2x M2 x 10mm long screw
• 2x M2 hex nuts

Installing Servo Mount

Place the micro servo over the 3D printed mount with the mounting holes lined up.

Secure Servo to Mount

Insert and fasten the M2 screws through the mounting tabs on the micro servo. 

Secure the micro servo to the mount using the hex nuts.

Servo Mount

Double check the orientation of the micro servo is installed correctly.