NeoPixel Wire

Create a 3-wire cable for the NeoPixel stick using the silicone ribbon cable.

Measure and cut the wires so they're 18cm in length. 

NeoPixel Wiring

Solder the wires to the 5VDC, GND and DIN pads on the NeoPixel stick.

Heat Shrink

Add a piece of red heat shrink tubing to the wire attached to the 5VDC pad.

Add a piece of white heat shrink tubing to the wire attached to the DIN pad.

Hardware for NeoPixel Mount

Gather up the following hardware for securing the NeoPixel stick to the NeoPixel mount.

• 2x M2.5 x 6mm long screws
• 2x M2.5 x 6mm long F-F hex standoff
• 2x M2.5 hex nuts

NeoPixel Standoffs

Secure the two M2.5 standoffs to the NeoPixel stick using the M2.5 x 6mm long screws.

NeoPixel Stick Mount

Secure the NeoPixel stick to the mount using the two M2.5 hex nuts.