Feather Screws

Get the following hardware ready to secure the Feather to the body cover.

• 2x M2.5 x 6mm long machine screws

Install Feather

Place the Feather onto the body cover with the mounting holes lined up with the standoffs.

Insert the Feather at an angle so the PCB is fitted underneath the clips. Then, snap fit the Feather onto the other clips. 

Secure Feather

Insert and fasten the screws through the Feathers mounting holes.

Connect Servo Cable

Plug the cable from the micro servo into the servo header pins. The brown wire goes to the G pin, red wire to V+ and yellow wire Sig pins.

Connect Speaker Wires

Insert the two wires from the speaker into the screw block terminals. 

Secure the speaker wires to the terminals using a flat head screw driver.

Connect Button Wire

Insert one of the wires from the button to the screw block terminals.

Secure the button wire to the terminal using a flat head screw driver.

Connect NeoPixel Power Wire

Insert the NeoPixel 5VDC wire to the screw block terminal.

Secure the wire to the terminal using the screw driver. 

Connect Ground Wires

Insert the two remaining ground wires to the screw block terminal.

Secure the two wires using the screw driver.

Connect NeoPixel DIN Wire

Insert the remaining NeoPixel wire to the screw block terminal. Secure using the screw driver. 

Connect Battery

Plug in the 500mAh battery cable to the battery port on the Feather.