Trinket M0

Save Subscribe

Trinket Tinning

We'll need to connect the wires from the micro switch to the pins on the Trinket M0. I like to add a bit of solder to the pins and then insert the wires.

Wiring Trinket M0

Solder the C1(common) wire to the ground (G) labeled pin and NO3(normally open) wire to pin number 0. 

Wired Trinket M0 and Micro Switch

Now our micro switch is connected to the Trinket M0, high five! Now we can start putting our circuit into the 3D printed enclosure. Before we get started, let's double check our work and make sure we have solid connections.

 Switch Assembly 

This guide was first published on Mar 21, 2018. It was last updated on Mar 21, 2018.

This page (Trinket M0) was last updated on Mar 15, 2018.

Text editor powered by tinymce.