Place

 

Align the PCB board over the printed plate. The small wall is positioned next to the JST port. 

The top part of the case is placed over the JST port. Align the nubs on each side of the case.

The nubs on the plate are aligned to the snaps on the top case. Press fit one side at at time to snap together. 

Snap

 

The case features a cutout for the built-in slide switch so you can still access the charging rate.

The JST connectors are covered to help keep out any dust to provide a bit of protection.

Charge

 

For use with Adafruit LiPoly/LiIon batteries only! Other batteries may have different voltage, chemistry, polarity or pinout.

 

Remember to move the slide switch on the top over to "High / 500mA" mode, for when charging batteries with 500mAh size or larger.

This guide was first published on Nov 30, 2022. It was last updated on Mar 08, 2024.

This page (Assemble) was last updated on Mar 08, 2024.

Text editor powered by tinymce.