Build a creepy, glowing test tube display... if you dare. A Feather microcontroller makes the UV LEDs shine to create dazzling effects in the fluorescent pigment-and-water filled test tubes. Easy-to-assemble black iron pipe forms the base of this labware set. The perfect prop for your own haunted house or creepy laboratory.
Thermocouples are very sensitive, requiring a good amplifier with a cold-compensation reference, as well as calculations to handle any non-linearities. For a long time we've suggested our MAX31855K breakout, which works great but is only for K-type thermocouples. Now we're happy to offer a great new thermocouple amplifier/converter that can handle just about any type of thermocouple, and even has the ability to give you notification when the temperature goes out of range, or a fault occurs. Very fancy! This converter communicates over 4-wire SPI and can interface with any K, J, N, R, S, T, E, or B type thermocouple
Add Internet to your next project with an adorable, bite-sized WiFi microcontroller, at a price you like! The ESP8266 processor from Espressif is an 80 MHz microcontroller with a full WiFi front-end (both as client and access point) and TCP/IP stack with DNS support as well. While this chip has been very popular, its also been very difficult to use. Most of the low cost modules are not breadboard friendly, don't have an onboard 250mA 3.3V regulator or level shifting, and aren't CE or FCC emitter certified....UNTIL NOW!
Did you know that the Arduino IDE can be used to program the micro:bit? Now you have yet another way to use this cool board! Learn how to set up Arduino to program your micro:bit, blink some LEDs, read the internal temperature sensor, send and receive data over Bluetooth - even log data to Adafruit.IO!
If you're here, it's because you were given the gift of electronics with an AdaBox! You are a beginner who is getting started with your AdaBox or you just want to relive what it's like being a beginner at electronics again. But most of all, you want to learn how to build and make stuff with electronics!
This FeatherWing will make it real easy to add datalogging to any of our existing Feathers. You get both an I2C real time clock (PCF8523) with 32KHz crystal and battery backup, and a microSD socket that connects to the SPI port pins (+ extra pin for CS). Tested and works great with any of our Feathers, based on ATmega32u4, ATSAMD21, Teensy, or ESP8266.