Cleaning Prints

Clean up is very simple. Leftover bits from retraction are easy to pull off with your hands. They shouldn’t be sharp, just be carful not to get any splinters!

Use flush diagonal cutters and a hobby knife to remove the excess material left behind during printing. You can use your fingers to rub away the loose bits. 

Use a flat putty like an iFixit jimmy to get in between crevices and remove tiny artifacts.

This guide was first published on Apr 28, 2015. It was last updated on Apr 28, 2015.

This page (Properties) was last updated on Apr 28, 2015.

Text editor powered by tinymce.