Download or Edit files

You can print out our design from thingiverse

or customize to make it your own on tinkercad

Dual Color Printing

Change Filament Option
Print your card in multiple colors by using the change filament option available in most FDM 3d printers. The first 1mm takes about 50 mins to print. At this point we can select the change filament option to swap out our color.

Z Pause Height
Z Pause Height allows you to pause your print at a set height. When you select this option, you will see two additional settings: Z Position and Pause Active.

Set the pause height to 1.1mm

Toggle the settings to ON. When Pause Active is set to ON, a Z height pause will be triggered, even if the Z Position is set to 0.

You can get filament from:

  • Inventibles
  • Makerbot
  • Ultimachine
  • Amazon
  • Print Settings

    Card
    About 50mins for the first color layer
    No Raft
    No Support
    2 Shells
    20% infill
    2.0 Layer Height
    90/150mm/s
    Gears
    5 mins
    No Raft
    No Support
    2 Shells
    10% Infill
    2.0 Layer Height
    90/150mm/s
    Heart
    15 mins
    No Raft
    No Support
    2 Shells
    10% Infill
    2.0 Layer Height
    90/150mm/s
    Pins
    3 mins
    No Raft
    No Support
    2 Shells
    10% Infill
    2.0 Layer Height
    90/150mm/s

    This guide was first published on Feb 04, 2014. It was last updated on Feb 04, 2014.

    This page (3D Printing) was last updated on Feb 03, 2014.

    Text editor powered by tinymce.