3D Printing

piplus-top.stl
piplus-bottom.stl
piplus-teeth.stl
@230 PLA
15% Infill
0.2 Layer Height
2 Shells
90/120 Speeds
about 2 hours 

Slicing Software

The recommend settings above should work with most slicing software. However you are encouraged to use your own settings since 3D printers and slicing software will vary from printer to printer.

PLA or ABS Material

We recommend using PLA material for an easier print with high quality. The tolerance has been tested with PLA filament but should also work with ABS. The parts do not require any support material or a raft.
This guide was first published on Aug 12, 2014. It was last updated on Oct 21, 2018. This page (3D Printing) was last updated on May 04, 2015.