Filament

This design was printed on a Printrbot in transparent yellow PLA filament. The tolerances are optimized for PLA, but should print well in ABS.
Easily switch out the design to either a chain necklace or knuckles, just swap out the lid of the enclosure!
Supports for:
knuckle.stl
knuckleBox.stl

No raft or support for:
knuckleBoxLID.stl
knuckle-lidClip.stl
knuckle-lidHoop.stl
ABS/PLA @240
10% Infill
2 Shells
0.2 Layer height
3 hours for all fours pieces 
knuckle.stl
Measure your middle and ring finger for a nice fit around your fist. The clips that hold onto the lid will require supports.

knuckleBox.stl

Print with the face down, the slide switch hole will require supports.

knuckleBoxLID.stl
This lid connects to the knuckleBox.stl via the knuckle-lidClip.stl

knuckle-lidclip.stl

Insert into the knuckleBoxLID.stl and slide the connected parts into the knuckle.stl clips.

This guide was first published on Jun 23, 2014. It was last updated on Jun 23, 2014.

This page (3D Printing) was last updated on Jun 23, 2014.

Text editor powered by tinymce.