Transparent PLA

Print the LED cover to soften and diffuse the NeoPixel ring. For most FDM 3D printers, PLA material works with out a heated bed. The extruder should be set to 230c. The model was design to print with out a raft or supports. Below is a small list of places to get PLA. Make sure your filaments diameter size matches your 3d printer. Most common size is 1.75mm and 3mm.

LED Base
About 35 minutes
5g
PLA @230
No Raft
No Support
2 shells
15% Infill
2.0 Layer Height
90/150mm/s
Enclosure + Cover
About 40 minutes
6g
PLA @230
No Raft
No Support
2 shells
15% Infill
2.0 Layer Height
90/150mm/s
Clip
About 35 minutes
7g
PLA @230
No Raft
No Support
2 shells
15% Infill
2.0 Layer Height
90/150mm/s
Hinge Connector
About 5 minutes
1g
PLA @230
No Raft
No Support

2 shells
15% Infill
2.0 Layer Height
90/150mm/s

LED Diffuser
About 20 minutes
4g
Transparent PLA @230
No Raft
No Support
2 shells
15% Infill
2.0 Layer height
90/150mm/s

This guide was first published on Jan 30, 2014. It was last updated on Jan 30, 2014.

This page (3D Printing) was last updated on Jan 26, 2014.

Text editor powered by tinymce.