- rods should be roughly the same length (+/- 2mm)
- rod-ends should be aligned
Time for some hot-glue.
Squeeze in a bit into the rod-end.
Push the rod in all the way...
Add a little more hot-glue around the base / rod to make it extra secure.
A couple things here.
Time to attach one end of the armature to a servo; start by cutting off one end of a servo horn.
Hot-glue the servo horn to the servo horn extension.
Screw the armature on...
And add an M3 nut to hold everything together.
This guide was first published on Nov 11, 2013. It was last updated on Nov 11, 2013.
This page (Assembly: Armature) was last updated on May 25, 2020.