Attach Arms

Depending on the material used, you may need to bend the ends of the pins to fit them into the arm socket.

Support Removal

Use our trusty flat pliers to remove the support material from the around the legs and pin holes.

Join Body

Snap together the top and bottom body parts by angling the top and sliding both pins in from the back.

Attach Head

Position the pin where to slits are and insert the head at an angle while pushing and turning at the time.
Twist the head back and forth to loosen the joint up.

Add Face

Place the head facing the ground and slide each eye in to place one at a time. You can rotate the eyes freely once they are in. Insert the mouth the same way.

Attach Ears

Plug in the ear pin into the each ear and then pinch the pins ends to insert them in the head.

Add electronics!

Now get creative and add sensors and LEDs to your new robot friend! The mouth has a different wall thickness, so you can light up the mouth without affecting the eyes!

This guide was first published on Jun 11, 2014. It was last updated on Jun 11, 2014.

This page (Assembly) was last updated on Jun 10, 2014.

Text editor powered by tinymce.