EYESPI
This display comes with an EYESPI connector, which is an 18pin 0.5mm pitch connector that allows you to use a flex cable to connect your display to your microcontroller. For more details, visit the EYESPI page.
Connection Pins
This color display uses SPI to receive image data. That means you need at least 4 pins - clock, data in, TFT CS and D/C. If you'd like to have SD card usage too, add another 2 pins - data out and card cs. However, there's a couple other pins you may want to use, lets go thru them all!
- GND - this is the power and signal ground pin
- Vin - this is the power pin, connect to 3-5VDC - it has reverse polarity protection but try to wire it right!
- D/C - this is the TFT SPI data or command selector pin. Use 3-5V logic level
- RESET - this is the TFT reset pin. Connect to ground to reset the TFT! Its best to have this pin controlled by the library so the display is reset cleanly, but you can also connect it to the Arduino Reset pin, which works for most cases. There is an automatic-reset chip connected so it will reset on power-up. Use 3-5V logic level
- SD Card CS / SDCS - this is the SD card chip select, used if you want to read from the SD card. Use 3-5V logic level
- LCD_CS - this is the TFT SPI chip select pin. Use 3-5V logic level
- MOSI - this is the SPI Microcontroller Out Serial In pin, it is used to send data from the microcontroller to the SD card and/or TFT. Use 3-5V logic level
- MISO - this is the SPI Microcontroller In Serial Out pin, its used for the SD card. It isn't used for the TFT display which is write-only. It is 3.3V logic out (but can be read by 5V logic)
- CLK - this is the SPI clock input pin. Use 3-5V logic level
- Backlite - this is the PWM input for the backlight control. It is by default pulled high (backlight on) you can PWM at any frequency or pull down to turn the backlight off. Use 3-5V logic level
Text editor powered by tinymce.