Prep SD breakout

Use an 8 pin matching cable pair to easily connect the SD breakout board to the pins on the Qualia board. Follow the wiring diagram here.

Mount display

Take note of how the ribbon cable attaches to the Qualia board. Align the display to the cutout and place face down between the walls inside the case. 

Slightly bend the case while gently pressing the edges of the display to fit. 

Mounting The Frame

Align cutout on the mounting frame to the ribbon cable

Slide the mounting frame into the case at an angle, between the snaps on the case.

Mount SD breakout

Align the SD breakout to the slot on the case.

Use M2.5x5mm screws to mount the SD breakout board to the frame.

Connect SD cable

Connect the SD cables to the Qualia. Coil the cable and place the connector between the three taller standoffs.

Use M2.5x5mm screws to secure the Qualia to the frame.

Display Ribbon

Carefully lift the connect bracket on the Qualia.

Place the display ribbon cable into the connector on the Qualia board and gently press the bracket back down to secure the ribbon cable into place.  

Attach Lid

Align the snaps on the lid the nubs on the inside of the case to close the enclosure.