16x32 RGB LED matrix panel with colorful text lit up
Bring a little bit of Times Square into your home with this 16 x 32 RGB LED matrix panel. These panels are normally used to make video walls, here in New York we see them on the sides...
$24.95
In Stock
5V 10A switching power supply brick with IEC power port.
This is a beefy switching supply, for when you need a lot of power! It can supply 5V DC up to 10 Amps, running from 110V or 220V power (the plug it comes with is for US/Canada/Japan...
$29.95
In Stock
5V 4A switching power supply brick with figure 8 power port.
Need a lot of 5V power? This switching supply gives a clean regulated 5V output at up to 4 Amps (4000mA). 110 or 240 input, so it works in any country. The plugs are "US...
$14.95
In Stock
5V 2A Wall Wart switching power supply
This is an FCC/CE certified and UL listed power supply. Need a lot of 5V power? This switching supply gives a clean regulated 5V output at up to 2000mA. 110 or 240 input, so it works...
$7.95
In Stock
Premium Female/Female Jumper Wires - 40 x 6"
Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires approximately 6" (150mm) long and come in a 'strip' of 40 (4 pieces...
$3.95
In Stock
Angled shot of Premium Male/Male Jumper Wires - 40 x 6 (150mm)
Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 6" (150mm) long and come in a 'strip' of 40 (4 pieces of each of...
$3.95
In Stock
Angle shot Female DC Power adapter - 2.1mm jack to screw terminal block
If you need to connect a DC power wall wart to a board that doesn't have a DC jack - this adapter will come in very handy! There is a 2.1mm DC jack on one end, and a screw terminal...
$2.00
In Stock